If An Error Is Detected In The Self-Check - Renesas Single-Chip Microcomputer M306NKT3 User Manual

M306NKT3-RPD-E User's Manual
Figure 2.7 Switch settings for the self-check (factory-settings)

2.7.2 If an Error is Detected in the Self-check

If the self-check does not result normally, check the following.
(1) Whether the emulation pod and PC4701 are connected properly
(2) Whether the proper firmware has been downloaded
(3) Whether the switch settings of this product are the factory-settings
Notes on Self-check:
Perform the self-check while not connecting the user system.
If the self-check does not result normally (excluding target status error), the emulation pod may be damaged.
Then contact your local distributor.
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006
SW1 BYTE
(factory-settings)
SW2 SW3
(factory-settings) (factory-settings)
SW4
SW5
(factory-settings)
(factory-settings)
M30620T3-PRT board
IMPORTANT
JP1 =
(factory-settings)
(factory-settings)
2. Setup
Page 29 of 104