Ip Address Of Self Station; Sub Net Mask +03 - Hitachi Hidic EH-150 Applications Manual

Preliminary Rev.03
5.2 Ethernet information configuration
It is required to configure the Ethernet information to this module before to start communication. The
Ethernet information is saved by the retained memory of this module as the part of setup.dat file.
The detail of the Ethernet information is shown in table 5.2.

IP address of self station

Sub Net Mask of self station
Sending receiving test
Default Gate Way address
Routing table 1
Routing table 6
For Task code
communication
usage
There are two ways to configure the Ethernet information.
(1) To configure using Web browser.
(2) To configure by ladder diagram in CPU module.
In any case, it is required to change the position of dip switch into "Ethernet information setting mode".
CAUTION
- It is possible to configure "Configuration of Ethernet information" by Web browser or ladder diagram. But the
configuration of "Parameters for communication" can be done by only Web browser.
- The both information of not only "Configuration of Ethernet information" but also "Parameters for communication"
are saved into setup.dat file.
The contents of this manual might be changed without notice.
Chapter 5 Configuration and procedure for starting communication
Table 5.2 Ethernet information
Items
Destination IP address
Logical port number
Network address
Sub Net Mask
Gate Way address
:
:
Network address
Sub Net Mask
Gate Way address
Logical port number of self station
Task code port 1
Type of service
Logical port number of self station
Task code port 2
Type of service
Logical port number of self station
Task code port 3
Type of service
Logical port number of self station
Task code port 4
Type of service
Timeout interval value
5-3
Default value
192.168.0.1
255.255.255.0
192.168.0.254
4000
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
3004
0 (TCP/IP)
3005
0 (TCP/IP)
3006
0 (TCP/IP)
3007
0 (TCP/IP)
0(No timeout)