Electrolux OEF5C50X User Manual page 91

ENGLISH 91
Make sure that the ventilation space of 2 mm, between the worktop and the front of
the below unit, is free. The warranty does not cover damages caused by the lack of an
adequate ventilation space.
The bottom of the appliance can get hot. We recommend to install a non-combustible
separation panel under the appliance to prevent access to the bottom.
Keep the transit bolts in a safe place. If the appliance is to be moved in the future they
must be reattached to lock the drum to prevent an internal damage.
Always keep the appliance vertical when it is being moved.
Adjust the feet to have the necessary space between the appliance and the flooring.
When the appliance is in its permanent position, check if it is levelled correctly with the
aid of a spirit level. If it is not, adjust the feet accordingly.
Do not install or use the appliance where the temperature can be less than 0°C or
where it is exposed to the weather.
The floor area on which the appliance is to be installed must be flat, stable, heat
resistant and clean.
Make sure that there is air circulation between the appliance and the floor.
The bottom of the appliance can get hot. Make sure to install a separation panel made
from plywood, kitchen carcass material or other non-flammable materials under the
appliance to prevent access to the bottom.
Do not install the appliance directly above a floor drain.
Remove all the packaging and the transit bolts including rubber bush with plastic
spacer.
Do not spray water on the appliance and do not expose it to excessive humidity.
The installation must comply with relevant national regulations.
The glass splashback must be assembled in place when the appliance operates.
Do not use the appliance before installing it in the built-in structure due to safety
manner.
GUID-DEBEE272-5D5E-47D9-B123-D825AA469AAC
VERSION: 8
REQUEST NO:
LSP ID:
1. LIBRARY OF PARAGRAPHS FOR CONREF
All electrical connections should be made by a qualified electrician.
The appliance must be earthed.
Always use a correctly installed shockproof socket.
Make sure that the parameters on the rating plate are compatible with the electrical
ratings of the mains power supply.
Do not use multi-plug adapters and extension cables.
Make sure not to cause damage to the mains plug and to the mains cable. Should the
mains cable need to be replaced, this must be carried out by our Authorised Service
Centre.
Connect the mains plug to the mains socket only at the end of the installation. Make
sure that there is access to the mains plug after the installation.