Electrolux OEF5C50X User Manual page 86

86 www.electrolux.com
Always use oven gloves to remove or put in accessories or ovenware.
Do not change the specification of this appliance.
If the mains power supply cable is damaged, it must be replaced by the manufacturer,
its Authorised Service Centre or similarly qualified persons to avoid an electrical
hazard.
Do not use high pressure water sprays and/or steam to clean the appliance.
Do not use a steam cleaner to clean the appliance.
Use only the food sensor (core temperature sensor) recommended for this appliance.
Do not use water spray or steam cleaner to clean the control panel.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the glass door
since they can scratch the surface, which may result in shattering of the glass.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the glass of
hinged lids of the hob since they can scratch the surface, which may result in
shattering of the glass.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the glass door or
the glass of hinged lids of the hob since they can scratch the surface, which may result
in shattering of the glass.
This appliance is not intended to be used on ships, boats or vessels.
Do not install the appliance behind a decorative door in order to avoid overheating.
Do not install the appliance on a platform.
This appliance must be connected to the mains with a H05V2V2-F type cable to
withstand the temperature of the rear panel.
This appliance must be connected to the mains with a H05VV-F type cable to
withstand the temperature of the rear panel.
This appliance must be connected to the mains with a DRT 8/2+10/2 type cable to
withstand the temperature of the rear panel.
Excessive spillage must be removed before the pyrolytic cleaning. Remove all parts
from the oven.
Be careful when you touch the storage drawer. It can get hot.
To remove the shelf supports first pull the front of the shelf support and then the rear
end away from the side walls. Install the shelf supports in the opposite sequence.
If the mains power supply cable is damaged, it must be replaced by the manufacturer,
its Authorised Service Centre or similarly qualified persons to avoid an electrical
hazard.
The means for disconnection must be incorporated in the fixed wiring in accordance
with the wiring rules.
The fixed wiring insulation must be protected, for example, by insulating sleeving
having an appropriate temperature rating.
WARNING: Ensure that the appliance is switched off before replacing the lamp to
avoid the possibility of electric shock.
The ventilation opening in the base must not be covered by a carpet, mat, or any floor
covering.
Clean the appliance with a moist cloth. Use only neutral detergents. Do not use
abrasive products, abrasive cleaning pads, solvents or metal objects.