Electrolux OEF5C50X User Manual page 88

88 www.electrolux.com
Ensure that the appliance is switched off before replacing the lamp to avoid the
possibility of electric shock.
To remove the shelf supports first pull the front of the shelf support and then the rear
end away from the side walls. Install the shelf supports in the opposite sequence.
If the glass ceramic surface / glass surface is cracked, switch off the appliance and
unplug it from the mains. In case the appliance is connected to the mains directly
using junction box, remove the fuse to disconnect the appliance from power supply. In
either case contact the Authorised Service Centre.
Remove any spillage from the lid before opening. Let the hob surface cool down
before closing the lid.
When you route the mains cable, make sure that the cable doesn't come into direct
contact (for example using insulating sleeving) with parts that can reach temperatures
of more than 50°C above room temperature.
Exhaust air must not be discharged into a flue which is used for exhausting fumes
from any appliances burning gas or other fuels.
The operating water pressure at the water entry point from the outlet connection must
be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa).
The appliance must be connected to the water mains using the new supplied hose
sets, or other new hose sets supplied by the Authorised Service Centre.
Old hose sets must not be reused.
Items that have been soiled with substances such as vegetable or mineral oil,
acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax
removers should be washed separately with an extra amount of detergent before
being dried in the washer dryer.
Items such as foam rubber (latex foam), shower caps, waterproof textiles, and rubber
backed articles and clothes, or pillows fitted with foam rubber pads should not be dried
in the washer dryer.
Never stop the washer dryer before the end of the drying cycle unless all items are
quickly removed and separated so that residual heat can dissipate.
The final part of the washer dryer cycle takes place without heat (cool down cycle) to
ensure that items reach a temperature that will not cause damage to them.
Metallic containers for food and beverages are not allowed during microwave cooking.
This requirement is not applicable if the manufacturer specifies size and shape of
metallic containers suitable for microwave cooking.
WARNING: Use only hob guards designed by the manufacturer of the cooking
appliance or indicated by the manufacturer of the appliance in the instructions for use
as suitable or hob guards incorporated in the appliance. The use of inappropriate
guards can cause accidents.
The control panel must be connected to specified heating unit with matching colours of
connectors, to avoid possible hazard.
CAUTION: The appliance must not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly switched on and off by a
utility.
WARNING: Unattended cooking on an appliance with fat or oil can be dangerous and
may result in fire.