Table of Contents
Advertisement
5.3 Creation of a lens file
balance change resulting from the lens' optical characteristics.
In that way, it optimizes GAIN, Flare, and W.SHADING
switched by selecting the lens number with the menu. It is
not necessary to readjust every time. Lenses supporting
automatically. In addition, the extender status is memorized.
Thus, automatic switching is possible by the extender answer
signal from the lens.
Constructing the environment
Construct the test environment as shown in the following
At the start, attach the "standard lens" to be used for the basic
setup of the camera. In addition, use a uniform white chart as
the subject. Adjust the light using a light meter so the entire
chart has uniform brightness.
Chart on which Kent paper, etc. has been pasted
and the entire surface is a uniform white.
Illumination
meter
Light
Light
Picture monitor
(connect if required)
UHL-43 2005 VER1 (E)
5 Camera Setting and Adjustment
Memo
cannot be created correctly.
under the same conditions. When the conditions change
between lenses. Therefore, if the light or the chart changes,
it cannot be judged whether the difference is due to the
lens, light, or chart.
Camera
SDI OUT connector
WFM
Coax cable
35
Advertisement
Table of Contents
