Table of Contents
Advertisement
2
Turn the MENU RE to align the cursor to the
"PRE SET FILE LOAD." Press the MENU RE.
3
Turn the MENU RE to align the cursor to the
"FILE SELECT." Press the MENU RE.
The cursor moves to the mode setting.
4
Turn the MENU RE to align the cursor to the
value to be set (ENGINER, FACTRY). Press the
MENU RE.
5
The cursor automatically moves to "LOAD
START." Press the MENU RE.
When the cursor moves to mode setting, the mode
setting value changes from "READY" to "START."
- When "CANCEL" is selected with the MENU RE,
the setting is cancelled, and "PRESET FILE LOAD"
ends.
- When "START" is selected, the lower section of the
screen indicates "PUSH SET -> START."
When "START" is set, the condition moves to Step 6.
6
Press the MENU RE.
Initialization starts.
on the screen. Then, "CAMERA RESTART" starts
blinking for approximately 3 seconds. Then, the
camera restarts up, and the initialization completes
Caution
It is necessary to understand the following points
before initializing this device.
(1) Initialization is not the same as "Restore" to the
original settings.
(2) The initialization of the engineering setting
items restores to a certain point in time, but the
contents may be different from your wish.
If the conditions when the data is saved and
conditions when the setting items are initialized
are different, the settings items may not be as
you desired.
(3) Restoring the factory settings may result in
losing your settings.
After understanding these points, if you still wish to
perform initialization, please follow the procedure
outlined above.
UHL-43 2005 VER1 (E)
6 Troubleshooting
45
Advertisement
Table of Contents
