Control Commands - Fenix TS2000 Series Operation Manual

6 – CONTROL COMMANDS
LF
[Name] Print and line feed
[Format] ASCII
Hex
Decimal
[Description] Prints the data in the print buffer and feeds one line, based on the current line spacing.
[Note] This command sets the print position to the beginning of the line.
[Reference] ESC 2, ESC 3.
CR
[Name] Print and carriage return
[Format] ASCII
Hex
Decimal
[Description] When automatic line feed is enabled, this command operates the same as LF; when
automatic line feed is disabled, this command is ignored.
[Notes] This command is effective only it is programmed with such functionality (see
●
command DC3 ESC FS GS).
Sets the print starting position to the beginning of the line.
●
[Reference] LF
DC3 p m ton toff
[Name] Enable digital output
[Format] ASCII
Hex
Decimal
<00>H ≤ m, ton, toff ≤ <FF>H
[Range]
[Description] Enables the digital output which can be triggered either by an error event or intentionally
The parameter m is composed by to nibbles. The high nibble sets the triggering event
while the lower one set the number of complete cycles to be output.
m (hex)
high nibble
LF
0A
10
CR
0D
13
DC3 p
13 70
19 112
m (hex)
low nibble
0 0 to F
1 0 to F
2 0 to F
3 0 to F
4 0 to F
5 0 to F
6 0 to F
7 0 to F
8 0 to F
9 0 to F
TS2000 PRINTERS OPERATION MANUAL
m ton toff
m ton toff
m ton toff
Function
No event. Output directly by command
Output triggered by hardware error
Output triggered by Vp voltage error
Output triggered by temperature error
Output triggered by cutter error
Output triggered by no-paper error
Output triggered by platen-opened error
Output triggered by black mark error
Output triggered by ticket not picked up error
Output triggered by paper-near-end error
27/58