Fenix TS2000 Series Operation Manual page 30

0
1
2
3
4
5
6
7
n = <05>H: Paper sensor status
Bit OFF/ON Function
0
1
2
3
4
5
6
7
DC3 ESC FS GS
[Name] Program printer settings
[Format] ASCII
Hex
Decimal
<00>H ≤ n ≤ <07>H
[Range]
[Description] Changes any of the programmable settings and saves them into non-volatile memory.
Any of the settings can be programmed simultaneously with any other settings.
n is the number of printer settings to be changed, and s1...sn indicates the type and
new value of the setting.
[Notes] Once the command has been sent the printer will save the new setting into non-
●
volatile memory and print a message indicating if the feature has been saved
successfully, or on the contrary if the feature is not supported. It is required,
therefore, to have the paper roll installed.
After this command has been executed, the printer will reset itself automatically in
●
order to activate new settings.
If communications setting are changed it will be required to change them also in the
●
host controller in order to restore communications.
The number and order of setting changed it is not important.
●
The changes may also be checked by printing the self-test.
●
OFF Not used. Fixed to OFF
ON Not used. Fixed to ON
- Undefined
OFF Paper near-end sensor: Paper present
ON Paper near-end sensor: Paper not present
ON Not used. Fixed to ON
- Undefined
OFF Paper real-end sensor: Paper present
ON Paper real-end sensor: Paper not present
OFF Not used. Fixed to OFF
OFF Not used. Fixed to OFF
ON Not used. Fixed to ON
- Undefined
OFF Ticket not pick up
ON Ticket pick up
ON Not used. Fixed to ON
- Undefined
- Undefined
OFF Not used. Fixed to OFF
DC3 ESC
13 1B
19 27
TS2000 PRINTERS OPERATION MANUAL
FS GS n
1C 1D n
28 29 n
s1...sn
s1...sn
s1...sn
30/58