Fenix TS2000 Series Operation Manual page 24

5.9.1- Error types
When any of these errors happen, the led blinks
with a different blinking timing sequence and
color for each of them according to the figure
below. If no error happens the led will light
permanently green.
Fig.5.6. Error status indicator LED.
1
No error
Near-end paper
Ticket not picked up
Hardware error
VP voltage error
Temperature error
Cutter error
Black mark error
No paper / door open
Fig.5.7. LED Blinking sequence. Each time unit corresponds to 0.5 seconds.
More information on these errors can be found below:
NEAR END PAPER WARNING
•
[Description] At run time, the printer checks periodically, through the near-end paper sensor,
if there is enough remaining paper in the paper roll. If the printer in running out
of paper the printer will warn visually the user. The print will not stop working.
This error is informational only (warning).
[Status flags] This error involves the following flags activation:
n=<04>H Continuous paper sensor status → Paper not present bit 3="1".
[Recover action] Change the paper roll by a new one.
5 10 15
TS2000 PRINTERS OPERATION MANUAL
20 25 30
24/58