Advertisement
DISASSEMBLY AND REASSEMBLY
Suggestions
1. Detent group (interlock mechanism) ~
installation
(1) Install lst-speed shift rail C18 and steel
balls C15 in that order.
(2) Insert interlock pin C14 into the hole of
2nd-speed shift rail C12, and put steel balls
ClO
and 3rd-speed shift rail C5 in that
order.
NOTE
Install the detent parts with each shift rail
held in NEUTRAL.
2. Bevel pinion shaft installation
(I) Measure dimension L from the end face of
pinion to that of transmission case, making
sure that it is as specified below:
L
=
46.2±0.1mm (1.819±0.004 in)
(2) The standard value of this dimension is
indicated on the end face of pinion. Refer
ring to that value, increase or decrease the
thickness of shims E4 to be fitted to pinion
shaft E12 on the opposite side of the pinion
if the dimension is greater or smaller than
the specification.
88
Advertisement
