Advertisement
DISASSEMBLY AND REASSEMBLY
5. Tilt clutch housing 9 with its rear (tansmis
sion) side lower than its front side, as ~hown,
and take the housing down.
6. For removal of the parts from the clutch
housing and removal of the pressure plate
assembly from the engine flywheel, follow
the steps under "Disassembly."
For disassembly and reassembly of the
gear pump, refer to GEAR PUMP FOR
TRANSMISSION AND STEERING
CLUTCHES.
Installation
To install, follow the reverse ofremoval sequence.
Off-the-machine method
Relief valve removal and installation
1. Remove the following parts:
1
Pipe
2 Bracket
3
Relief valve
4
Block
2. When installing the valve to the block, apply
a coat of oil to the 0-ring of the gear pump
side connector.
B
602447
73
Advertisement
