Advertisement
DISASSEMBLY AND REASSEMBLY
Installation
To install, follow thereverseofremoval sequence.
Suggestions
1. Insert bolt into each mount bracket from the
upper side, and locate the bracket relative to
the frame.
2. After the engine has been, lowered onto the
brackets, check top clearance B and bottom
clearance A.
(1) Put shims 1 and washer 2 on bottom side
and shims 3 and washer 4 on top side.
(2) Check to make sure that clearance A be
tween the bottom end of mount bracket and
washer2js 1.8 to 2.8mm (0.07 to 0.11 in.).
If this clearance is zero (0) at one or more
brackets, replace all brackets.
(3) With mount bolt 5 in place, see if clearance
B is 1.2 to 2.2mm (0.05 to 0.09 in.); if not,
decrease or increase the thickness of shims
3 to set the clearance within this range at
each bracket.
(4) Tighten castle nut 6 to the specified t9rque.
(5) After tightening all mount bracket bolts,
check to make sure the engine and clutch
assembly is nearly horizontal.
LNOTE~J
If the engine and clutch assembly is not
horizontal, increase or decrease the thick
Lness
of shims 1.
and shims
58611-11200 t=4mm (0.16 in.)
58611-02400
t=
6mm (0.24 in.)
58611-02500
64361-74611
t=
1mm (0.04 in.)
64361-74612
t
=
0.5 mm(0.02 in.)
64361-175 16
t
=
0.5 mm (0.02 in.)
(1) Make sure the electric wires, pipes and
hoses are properly routed and connected.
(2) Adjust the clutch pedal. (Refer to TEST
ING AND ADJUSTING.)
(3) Adjust the engine control.
(4) Fill the engine and clutch with recom
mended oil and coolant.
1
Shims
2
Washer
5
Bolt
Inspection after installation
Washers
Washer
Washer
Shim set
Shim
70
Advertisement
