Advertisement
DISASSEMBLY AND REASSEMBLY
Suggestions
1. Clutch housing removal
Remove oil filler 3 from the threaded hole (MlO
—
1.25) at the top of housing 45. Attach a hook
in that threaded hole, and hoist the housing.
2. Pressure plate assembly removal
Before removing pressure plate assembly, mark
pressire plate 56 and clutch cover 55. Install
clutch disc arbor A (special tool) in the splined
hole of clutch disc, and run guide bolt B into each
clutch spring hole. Tighten the guide bolts to
compress the clutch springs lightly, and remove
the pressure plate assembly.
Inspection
1. Clutch discs
Measure the face runout, facing wear and
looseness of mating splines. Replace the disc if
any of these measurements exceeds the service
limit.
Unit: mm
(in.)
[~
Item
Assembly standard
Service limit
:
—0.4 (—0.016) for
Thickness
5.7 to 6.3:
one side
of facing
(0.224 to 0.248)
—0.8 (—0.031) for
• ~
both sides
Face runout
0.7 (0.028);,
0.7(0.028)
maximum
Looseness
of rnatmg
(0.0020
0:0C59)
0.30 (0.0118)
75
Advertisement
