Table of Contents
Advertisement
US/CA
5.6
Setting up a vacation program
If you leave the house for several days, you can
set in the vacation program that there will be
neither heat nor hot water produced during this
time.
The otherwise applicable heating and DHW
programs are not affected by this. The frost
protection is also guaranteed during the vacation
program.
The vacation program works with the following
factory settings:
Heating circuit 1 and Heating circuit 2:
•
Frost
Domestic hot water: 60 °F (15 °C)
•
DHW recirculation pump: Off
•
Thermal disinfection: Off.
•
The factory settings guarantee
energy-saving and safe operation
during your vacation.
If you would nevertheless like to
change the factory settings, you
will find the possible settings in
the detailed installation and
operating instructions.
1) Hot water heating with hot water tank
2) Hot water heating with combi boiler
5.6.1 Setting the beginning of vacation
B Open flap.
B Press the menu button.
The MAIN MENU is displayed, the Vacation
menu option is marked.
1)
2)
/ Off
Fig. 19
B Press the dial.
The vacation menu is displayed, the Start
menu option is marked.
B Press the dial.
The input field for the year flashes.
B Turn the dial to set the year.
B Press the dial to confirm the setting.
The input field for the month flashes.
B Set the month and day in the same manner as
the year.
After confirmation of the day, the Start menu
option is marked again.
Operation with open flap | 25
If you have set the vacation
program to start on today's date, it
will start immediately.
Otherwise the vacation program
will start at 12:00am (00:00) on the
set day.
9
12
h
6
3
24
h
Vacation menu option
6 720 643 262 (2010/05)
15
18
21
6 720 643 262-38.1O
Advertisement
Table of Contents
