Table of Contents
Advertisement
M30290T2-CPE User's Manual
1.3 Specifications
Table 1.5 lists specifications of the M30290T2-CPE.
Table 1.5 M30290T2-CPE specifications
Applicable MCUs
Evaluation MCU
Usable mode
Maximum operating frequency
Applicable power supply
Basic debugging functions
Real-time trace function
Real-time RAM monitor function
Hardware break function
Execution time measurement function
Connection to user system
(see "2.8 Connecting the User System"
on page 30)
Power supply for emulator
Host machine interface
Overseas standards
* Available to connect the host machine that supports USB 2.0. With the USB interface, not all hardware (such as host
machine, USB devices, USB hub) combination will work and guaranteed.
REJ10J0494-0200 Rev.2.00 July 16, 2005
M16C/26A, M16C/28, M16C/29 Groups
M30290FCWP
ROM size: 128 KB + 4 KB, RAM size: 12 KB
Single-chip mode
20 MHz at 3.0--5.5 V
10 MHz at 2.7--5.5 V
User system connected
(JP1=EXT)
User system not connected
(JP1=INT)
- Download
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
- 64K-cycle bus information recordable
(Address: 20 bits, Data: 16 bits, MCU status: 12 bits)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
- 1,024 bytes (256 bytes x4)
- Data/last access result
2 points (Address match, bus match, max. 256 pass counts)
Time between program start and stop
For 42-pin 0.8-mm-pitch SSOP (42P2R-E)
M30263T-42SSB (included with the M30263T2-CPE-FP)
For 48-pin 0.5-mm-pitch LQFP (48P6Q-A):
M30260T-48FPD (included with the M30260T2-CPE-GP)
For 64-pin 0.5-mm-pitch LQFP (64P6Q-A):
M30291T-64FPD (included with the M30291T2-CPE-HP)
For 80-pin 0.5-mm-pitch LQFP (80P6Q-A):
M30290T-80FPD (included with the M30290T2-CPE-HP)
DC 5.0 V ±5 %/(2 A) externally supplied (Prepare a power supply which
complies with CE marking requirements separately.)
USB (USB 1.1 full-speed *, mini-B standard connector)
EN55022: 1998 Class A, EN55024: 1998
2.7--5.5 V
3.3 V or 5.0 V
(supplied from the emulator, set by JP2)
1. Outline
Page 18 of 86
Advertisement
Table of Contents
