Table of Contents
Advertisement
M30290T2-CPE User's Manual
5. Troubleshooting
This chapter describes how to troubleshoot when this product does not work properly.
5.1 Flowchart to Remedy the Troubles
Figure 5.1 shows the flowchart to remedy the troubles from when power to the emulator is activated until the emulator
debugger starts up. Check this while the user system is disconnected. For the latest FAQs visit the Renesas Tools Homepage.
Turning on emulator
Front panel LED
of emulator
Init dialog box of
emulator debugger displayed
MCU Setting dialog box
of emulator debugger displayed
Program window of
emulator debugger displayed
Emulator debugger startup completed
Figure 5.1 Flowchart to remedy the troubles
REJ10J0494-0200 Rev.2.00 July 16, 2005
http://www.renesas.com/en/tools
1. Check connection of the power supply cable.
Normal
See, "2.4 Connecting the Power Supply for Emulator" (page 22).
2. Check that the power is properly supplied to the user system.
See "2.6 Turning ON the Power Supply" (page 24).
Not normal/Error displayed
1. Check the operating environment etc. of the
Normal
See the user's manual of the emulator debugger.
2. Reinstall the emulator debugger.
Not normal/Error displayed
See "5.2 (2) MCU Setting Dialog Box Does Not Appear at Debugger
Normal
Startup" (page 80).
See "5.2 (3) Errors Occur at Debugger Startup" (page 81).
Normal
Not normal
Error displayed
5. Troubleshooting
emulator debugger.
Page 78 of 86
Advertisement
Table of Contents
