Init Dialog Box - Renesas M30290T2-CPE User Manual

M30290T2-CPE User's Manual

3.2 Init Dialog Box

The Init dialog box is used to set the items that need to be set when the emulator debugger starts up. The contents set in this
dialog box remain effective the next time you start the debugger.
(1) MCU tab
1. Specifying the MCU file
Cancel
2. Using or not using the address match break function
Cancel
REJ10J0494-0200 Rev.2.00 July 16, 2005
Help
Help
3. Usage (How to Use the Emulator Debugger)
Specifying the MCU file
Click the "Refer..." button.
A file selection dialog box will be displayed, so select the
MCU file corresponding to the target MCU.
- The MCU file contains the information specific to the
target MCU.
- The MCU file you have selected is displayed in the MCU
section of the MCU tab.
Serial No.
Shows the currently connected emulators in list form. Select
the serial No. of the emulator you want to be connected.
Using or not using the address match break
function
Specify whether or not to use the address match break
function.
- To use the address match break function (default), select
the check box. In this case, the address match interrupt is
used by the emulator, and cannot be used in the user
program.
- When not using the address match break function,
deselect the check box (check mark cleared). In this case,
the address match interrupt can be used in the user
program.
This option can be selected or deselected only when you are
starting up the emulator debugger.
Page 42 of 86