Renesas M30290T2-CPE User Manual page 27

M30290T2-CPE User's Manual
Figure 2.9 Target status LEDs display when the emulator starts up normally (when user system connected)
Note on the Target Status CLOCK LED:
If the LED is not turned on, check the following.
(1) After powering on the emulator (before starting up the emulator debugger):
Make sure that the oscillator circuit board is properly installed in the emulator and it is oscillating normally.
(2) After the emulator debugger is started up (after the Init dialog box settings are completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
REJ10J0494-0200 Rev.2.00 July 16, 2005
When the user system connected :
If the POWER LED does not light, shut off the
system and check the setting of the jumper
switches and if the power is properly
supplied to the user system.
: ON
: OFF
IMPORTANT
POWER LED 3
CLOCK LED 4
RESET LED 5
RUN LED 6
2. Setup
Page 27 of 86