Renesas M30290T2-CPE User Manual page 44

Compact emulator for m16c/26a, 28, 29 groups
Table of Contents

Advertisement

M30290T2-CPE User's Manual
5. Executing the self-check
Cancel
(2) Debugging Information tab
1. Specifying the compiler used and the object format
Cancel
REJ10J0494-0200 Rev.2.00 July 16, 2005
Help
Help
3. Usage (How to Use the Emulator Debugger)
Executing the self-check
Enable this function when you want the emulator to be self-
checked at startup. Be sure to select the check box only
when you want the emulator to be self-checked at startup.
This function may be enabled in the following cases:
- When you are using the emulator you have just
purchased
- When you fail to download the firmware
- When you successfully download the firmware, but fail
to start up the emulator
- When you want to confirm whether the emulator is
operating normally because, for example, the MCU runs
out of control or something is wrong with the trace
results
Select the check box and click OK button. After connecting
to the emulator and confirming the firmware, the debugger
will immediately start self-check on the emulator.
This function can be enabled only when you are starting up
the emulator debugger.
Specifying the compiler used and the object
format
Displays the compiler used and its object format.
Please specify the compiler used and its format in the dialog
opened by menu [Debug]->[Debug settings...].
Specifying the method for storing debug
information
There are two methods for storing debug information: on-
memory method and an on-demand method.
When selecting the on demand method, check the [On
Demand] check box.
- On Memory
Debugging information is stored in the internal memory
of your computer. This method is suitable when the load
module (user program) size is small.
- On Demand
Debugging information is stored in a reusable temporary
file on the hard disk of your computer.
Because the stored debugging information is reused, the
next time you download the same load module it can be
downloaded at high speed. This method is suitable when
the load module (user program) size is large.
Page 44 of 86

Advertisement

Table of Contents
loading

Table of Contents