Table of Contents
Advertisement
M30290T2-CPE User's Manual
2. Setup
(2) Using an Oscillator Circuit on the User System
To operate this product with an external clock, construct an oscillator circuit as shown in Figure 2.19 in the user system and
input the oscillator output at 50% duty (within the operating range of the evaluation MCU) into pin X
. And pin X
should
IN
OUT
be open. Choose "External" in the emulator debugger to use this clock.
Figure 2.19 External oscillator circuit
Make note that in the oscillator circuit shown in Figure 2.20 where a resonator is connected between pins X
and X
,
IN
OUT
oscillation does not occur because a converter board and other devices are used between the evaluation MCU and the user
system. It is same for sub-clock oscillator circuits (X
and X
).
CIN
COUT
Figure 2.20 Circuit in which oscillation does not occur
REJ10J0494-0200 Rev.2.00 July 16, 2005
Page 39 of 86
Advertisement
Table of Contents
