Setup; Flowchart Of Starting Up The Emulator - Renesas M30290T2-CPE User Manual

M30290T2-CPE User's Manual

2. Setup

This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.

2.1 Flowchart of Starting Up the Emulator

The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to "5. Troubleshooting" (page 78).
Check the package components.
User registration
Install the emulator debugger.
Set the MCU power voltage
selection jumper (JP2).
Connect the USB interface cable.
Connect the power supply for the emulator.
Connect the user system.
Turning on the power supply.
Check the LED display of the emulator.
Start up the emulator debugger.
Set the operating environment
of the emulator debugger.
Debug a program with various functions of
the emulator debugger.
Figure 2.1 Flowchart of starting up the emulator
REJ10J0494-0200 Rev.2.00 July 16, 2005
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓
Refer to "1.1 Package Components (page 13).
Refer to "User Registration" (page 11).
Install it from the included CD-ROM.
Select a power voltage supplied to the target MCU.
Connect the USB interface cable to the USB interface connector
(J2) of the emulator and the USB port of the host machine.
Connect a power supply to the power connector (J1). Power supply
should be 5.0 V ±5%, 2 A.
Connect the user system as occasion demands.
Turn on the power to the emulator and the user system as
simultaneously as possible.
Check that the system status LED, and POWER and RESET of
target status LED are lighting. When the user system is not
connected, the POWER of target status LED does not light up.
Start up the emulator debugger.
Set the INIT dialog box and MCU Setting dialog box of the
emulator debugger.
For how to use the emulator debugger, refer to the online manual.
2. Setup
Page 20 of 86