Connecting To A 100-Pin 0.65-Mm-Pitch Foot Pattern (Part 1) - Renesas Emulation Probe for M32C/87 Group M30870T-EPB User Manual

M30870T-EPB User's Manual

2.9.2 Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 1)

Figure 2.9 shows how to connect the emulation probe to a 100-pin 0.65-mm-pitch foot pattern on the user system with the
M3T-DUMMY100S (not included), and here following is its procedure.
For details on the M3T-100LCC-DMS and M3T-DUMMY100S, refer to each user's manual.
(1) Attach the M3T-DUMMY100S to the user system.
(2) Attach the M3T-100LCC-DMS to the M3T-DUMMY100S.
(3) Attach the M30800T-PTC to the M30870T-EPB.
(4) Attach the M30800T-PTC to the M3T-100LCC-DMS.
Figure 2.9 Connecting to a 100-pin 0.65-mm-pitch foot pattern (1/3)
Notes on Connecting the User System:
Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator
and user system.
The small connectors of the M3T-100LCC-DMS and M3T-DUMMY100S are guaranteed for only 20
insertion/removal iterations.
The small connectors of the M30870T-EPB and M30800T-PTC are guaranteed for only 50 insertion/removal
iterations.
REJ10J0482-0300 Rev.3.00 February 16, 2006
M3T-FLX160-EPB
M30870T-EPB
CN2 side
(3)
M30800T-PTC
M3T-100LCC-DMS
(not included)
(4)
(2)
M3T-DUMMY100S
(not included)
100 -pin 0.65-mm- pitch
(100P6S) foot pattern
(1)
No. 1 pin
User system
CAUTION
On-board evaluation
FLASH MCU etc.
Page 31 of 104
2. Setup