Led Display When The Emulator Starts Up Normally - Renesas M30290T2-CPE User Manual

M30290T2-CPE User's Manual

2.6.5 LED Display When the Emulator Starts Up Normally

After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.7
shows the positions of the emulator status LEDs.
System status LEDs
Target status LEDs
Figure 2.7 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.8 when the user system is not connected and as shown in Figure 2.9 when a user
system is connected. After turning on the power, only the LED5 (RESET) lights on. Check the target status LEDs
display normally after starting up the emulator debugger.
When the target status LEDs do not display as shown in Figures 2.8 and 2.9, refer to "5. Troubleshooting" (page 78).
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system not connected)
REJ10J0494-0200 Rev.2.00 July 16, 2005
POWER
LED1
POWER
SAFE
SAFE
LED2
LED3
POWER
POWER
CLOCK
CLOCK
RESET
RESET
RUN
RUN
LED6
COMPACT EMULATOR
When the user system NOT connected:
The POWER LED does not light.
: ON
: OFF
POWER USB
5.0V
SYSTEM
STATUS
J1
COMPACT EMULATOR
M30290 T2-CPE
TARGET
STATUS
MADE
MADE IN JAPAN
POWER
CLOCK
RESET
RUN
SW1
J2
5.0V
JP2
3.3V
EXT
JP1
INT
LED 3
LED4
LED5
LED6
Page 26 of 86
2. Setup