Maintenance - MICRO-EPSILON capaNCDT 6110 IP Operating Instructions Manual

Maintenance

7.
Make sure that the sensor surface is always clean.
Disconnect the power supply before touching the sensor surface.
> Static discharge
> Danger of injury
If the controller, the sensor or the sensor cable is
defective, please send us the effected parts for
repair or exchange. In the case of faults the cause
of which is not clearly identifiable, send the whole
measuring system back to
Sensors of the same type can be replaced without calibrating the controller.
capaNCDT 61xx/IP
Maintenance
Switch off the power supply before cleaning.
Clean with a clamp cloth; then rub the sensor surface dry.
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Str. 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
info@micro-epsilon.de
www.micro-epsilon.com
Seite 37