Planmeca FIT CAD System User Manual page 43

Delete Low Density Areas
Interim model
Model
Restore Defaults
User's manual
Enable this option to remove low data. When enabled you can adjust the
automatic fill of low density data in the generated model by dragging the
Density Threshold slider to increase or decrease the level of data shown on
the model.
On the upper image the low density ares are removed.
Show Edges
Before the model is generated, the areas with insufficient data are higlighted
in light blue.
Resolution
• By increasing (+) resolution more filtering is applied and saturated (too
bright) points are deleted when scanning the model. This increases
accuracy but might slow down scanning.
• By decreasing (-) resolution less filtering is applied.
To restore the default settings, click this button.
10 Scan tab overview
Planmeca FIT CAD/CAM system
Low
35