Planmeca FIT CAD System User Manual page 32

9 Setting up restoration
24 Planmeca FIT CAD/CAM system
• Universal Numbering System adopted by the ADA (American Dental
Association).
The numbering system can be set in Planmeca Romexis Configuration
application, for more information see Planmeca Romexis Technical
manual (publication number 10037884).
1. Start the setup by selecting the restoration site by clicking on the tooth /
teeth on the anatomical model.
The currently selected tooth shows in orange. Any other teeth that are
part of the restoration show in green.
If no teeth have been selected, the anatomical model is closed until you
approach with it with the mouse cursor.
For bridges, select the abutments and the pontic(s). You can do up to 16
restorations on the same arch at one time.
• If you accidentally select a wrong tooth right-click the tooth and
select Deselect, then select the correct restoration site.
• If no teeth have been selected the jaws of the anatomical model will
close. To enable selection place the cursor over the model.
User's manual