Planmeca FIT CAD System User Manual page 15

4 Safety precautions
WARNING
The wireless components in the Planmeca products may be interfered with
by other equipment, even if the other equipment is fully compliant with
CISPR (International Special Committee on Radio Interference) emission
requirements.
WARNING
When possible, electrical equipment should not be used when adjacent to
other electrical equipment. If adjacent use is necessary, the equipment
should be observed to verify normal operation in the configuration in which it
will be used.
CAUTION
Comply with all applicable regulations when disposing of waste materials
from the Planmeca products.
WARNING
The PlanScan scanner's Thunderbolt cable may only be used with
computers that have an appropriate NRTL listing mark for ITE or Laboratory
Equipment or a Listing Classification mark for Medical Equipment.
WARNING
The Planmeca scanner is a high precision Class 2 laser scanning
instrument. Always store the scanner in its holder when not in use. To
prevent damage or misalignment, do not drop or strike the scanner. Follow
all stated precautions when using the scanner.
WARNING
To prevent electrical shock and eye damage by laser radiation, do not open
any sealed covers or connectors with user restricted access.
WARNING
In case of emergency unplug the scanner from the computer port and/or
unplug the computer power cord from the wall or from the computer.
WARNING
The Planmeca scanner is designed to be used with the tip connected to the
scanner. The connector pins on the scanner are energized when the tip is
removed. To ensure safety of the user and patient, do not touch the pins
when the tip is removed.
WARNING
The Planmeca PlanScan is a Class 2 Laser Product and will not present any
safety hazards under normal operation. Always observe safe laser practices.
Project the laser only onto surfaces or materials as directed by Planmeca
instruction material. Avoid shining the beam directly into the eye. Use the
laser product only as described in this manual.
User's manual Planmeca FIT CAD/CAM system 7