Configuration Steps – As/400; Configure The Ips Printer For Tcp/Ip At The Gui; Create The Psf/400 Configuration - Xerox DocuPrint 180 IPS Installation Planning Manual

Configuration steps – AS/400
Configuration worksheet
Item description
Device description DEVD
Remote location
Port number
PSF configuration

1. Configure the IPS printer for TCP/IP at the GUI

2. Create the PSF/400 configuration

XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
Follow these steps to configure your AS/400 to print to an IPS printer
connected to the LAN, using TCP/IP.
The following worksheet will help you in planning the IPS installation.
It describes the key values which you need to supply when planning
the AS/400 configuration. All values on this worksheet must be
determined before you begin the printer configuration on the host.
Table E-14.AS/400 configuration worksheet for IPS
Also known as... Source
This is the name of the printer (writer).
An Output Queue of the same name is
automatically created. Spool files that
you place in this Output Queue are
directed to the printer.
RMTLOCNAME Xerox IPS software installation. This is
the printer IP address.
PORT IPS configuration Interface window and
subwindows. The value 5001 works
best for IPDS printers.
PSFCFG Same as Device description
Note: It is assumed that your AS/400 is connected to the LAN and
all the prerequisite software is installed and configured.
Refer to the "Setting the system configuration" chapter of the Guide
to Configuring and Managing the System for this graphical user
interface (GUI) procedure.
Follow these steps to configure PSF/400 for the IPS printer.
1. At the AS/400, press <F4> to prompt the CRTPSFCFG
command.
2. Key in the parameter values as indicated in the figure below.
For parameters with
configuration worksheet, earlier in this section.
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
* beside them, refer to the
Your value
E-19