Xerox DocuPrint 180 IPS Installation Planning Manual page 145

Item
description Default
PROC None
AUTOSTOP NO
HASPFSSM HASPFSSM
CLASS None
COPYMARK DATASET
FORMS None
FSS None
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
SYS1.PROCLIB, although your system may use a different
library.)
The JES2 PROC has a DD statement (normally HASPPARM),
which points to the initialization dataset. (The location of this
statement is 'SYS1.PARMLIB(JES2PARM);' however, you
should always verify the location on your own system.)
2. Enter the following required commands in the JES2 initialization
dataset to define the PSF functional subsystem (FSS):
•
•
The following table lists the JES2 FSS statement parameters to
be defined.
Table E-1.JES2 FSS statement parameters
Range of
Source of value acceptable values Comments
PSF Startup procedure 1 to 8-character
name/ alphanumeric string
Installation YES or NO
preferences
JES2 Load module to HASPFSSM
be loaded into FSS
address space
Installation output List of
class standards alphanumeric
output classes
Installation DATASET or JOB
preferences or CONSTANT
Forms that will be 1 to 8 form names
printed on this printer (each 1 to 8
alphanumeric
characters in
length)
Name of FSS 1 to 8-character
alphanumeric string
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
One FSS statement for each PSF functional subsystem
One PRTnnnn statement for each functional subsystem
application (FSA) under control of the FSS. (This can also
be specified as PRINTnn or PRINTERn.)
Specifies name of
procedure for starting this
FSS. Different FSS
statements can refer to the
same startup procedure.
Specifies whether FSS
address space is stopped
automatically if all FSAs
under control of the FSS
are stopped.
Either omit parameter or
specify default value of
HASPFSSM.
Can also be specified as
QUEUE=
DATASET: IPS printer will
offset-stack or stitch on a
dataset boundary.
JOB: IPS printer will offset-
stack or stitch on a job
boundary.
CONSTANT: Copymarks
are constant; no offset
stacking or stitching is
done.
If WS is F, only output with
these form names will be
selected for printing on this
printer.
Required
Your value
E-3