Create The Printer Device Description – As/400 - Xerox DocuPrint 180 IPS Installation Planning Manual

DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Type choices, press Enter.
PSF configuration.........
User resource library list.
Device resource library list....
IIPDS pass through.......
Activate release time.....
Release time.............
Restart timer............
SNA retry count..........
Delay time between SNA retries..
Text 'description'........
Additional parameters....
Blank page...............
Page size control........
Resident font............
Resource retention.......
Edge orient..............
Remote location:
TCP/IP port..............
TCP/IP activation timer...
3. Create the printer device description – AS/400
E-20
Table E-15.Create PSF Configuration screen – AS/400
Create PSF Configuration (CRTPSFCFG)
Library.................
+ for more values
Name or address........
Follow these steps to create the device description for the IPS
printer.
1. At the AS/400, press <F4> to prompt the CRTDEVPRT
2. Key in the parameter values as indicated in the appropriate
> XEROXIPS
> QGPL
*JOBLIBL
*DFT
*NO
*NORDYF
> *SEC15
> *IMMED
2
0
*BLANK
*YES
*NO
*NO
*YES
*NO
> '9.9.999.999'
> 5001
170
command.
figure below.
•
Table E-16 shows printer description parameters for OS/
400 with V3R7 installed.
•
Table E-17 shows parameters for OS/400 with V3R2
installed.
For parameters with
configuration worksheet, earlier in this section.
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
*
*
*
* beside them, refer to the