Configure The Printer In Psf/Mvs - Xerox DocuPrint 180 IPS Installation Planning Manual

4. Configure the printer in PSF/MVS

Item
description Default
APPLID None
BUFNO
FAILURE
FDEFDD None
FONTDD None
FORMDEF None
IPADDR None
JOBHDR None
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
Follow these steps to configure the IPS printer in PSF:
1. Locate the PSF startup procedure in the JES3 or JES2 startup
JCL procedure. This is normally kept in SYS1.PROCLIB,
although your system may use a different library.
The libraries specified by the //PROC00 DD statement normally
contains startup procedures for PSF subsystems. The name of
the procedure is specified in the initialization dataset (FSS
statement PROC parameter in JES2; the FSSDEF statement
PNAME parameter in JES3. See the appropriate section in this
appendix for clarification).
2. Add a PRINTDEV statement to define the IPS printer in PSF.
(See the example below for the general format or the PSF
Systems Programming Reference for more information.
The table below contains descriptions of the PSF parameters
which need to be set for the IPS printer.
Table E-5.PSF/MVS PRINTDEV statement parameters
Source of Range of
value acceptable values Comments
VTAM APPL 1 to 8-character
statement alphanumeric string
N/A 5 to 100
Installation WCONNECT or
preferences STOP
Installation 1 to 8-character
preferences alphanumeric string
Installation 1 to 8-character
preferences alphanumeric string
Installation 1 to 6-character
preferences alphanumeric string
Xerox IPS Valid IP address in
installation dotted decimal
format, enclosed in
quotes
Installation 1 to 8-character
preferences alphanumeric string
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Not applicable for TCP/IP-
attached printer.
Not applicable for TCP/IP-
attached printer.
If IPS is used by other
hosts, WCONNECT
causes PSF to
continuously retry to
establish connection with
printer.
Name of the form definition
library DD statement.
Name of font library DD
statement. Fonts in this
library must match
resolution the IPS is using.
Name of default
FORMDEF for IPS printer.
Example:
IPADDR='12.345.676.89'
Name of OUTPUT
statement that defines form
and page definition used to
format job header
separator pages.
Your value
E-7