Xerox DocuPrint 180 IPS Installation Planning Manual page 108

SUPPLIES
Paper size/pitch mode minimum and
A-4
Table A-3.
Pitch
8
7
6
5
4
3
When the printing speed appears to degrade, you may be able to
improve it by running the print job in a higher pitch mode.
The illustrations in this section show the pitch modes in which you
maximum can operate with the smallest and largest size papers supported by
the 96/4635/180 printer.
Using small paper sizes in 8-pitch mode:
Printing in 8-pitch mode provides the highest throughput speed
available —up to 154 ppm for the 4635 printer and up to 206 ppm for
the 180 printer. (The 96 printer does not support 8-pitch mode.)
However, you should keep the following in mind when you select the
paper you want to use for this mode:
•
Paper sizes smaller than 8 inches / 203 mm are supported only
when the optional 7-inch paper kit is installed on the printer.
•
The leading edge of any paper used in the printer cannot be
less than 10 inches / 254 mm long.
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
Throughput data: 180 printer
Paper width
7 to 7.4 in. / 178 to 188 mm
7.4 to 9.01 in. / 188 to 229 mm
9.01 to 10.19 in. / 229 to 259 mm
10.19 to 12.12 in. / 259 to 308 mm 128 ppm
12.12 to 15.31 in. / 308 to 389 mm 103 ppm
15.31 to 17 in. / 389 to 432 mm
Speed
206 ppm
180 ppm
154 ppm
77 ppm