Xerox DocuPrint 180 IPS Installation Planning Manual page 146

DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Item
description Default
MARK NO
MODE FSS (if FSS=
is coded)
PRESELECT YES
ROUTECDE None
START YES
TRKCELL no
WS None
FSS (FSS1)
PRT0001
Configuring in JES3
E-4
Table E-1.JES2 FSS statement parameters (continued)
Range of
Source of value acceptable values Comments
Installation YES or NO
preferences
Must be FSS FSS
Installation YES or NO
preferences
Installation printer 1 to 4 destination
name standards names
Should be NO for TCP/ YES or NO
IP printers.
See JES2 SPOOLDEF YES or NO
statement
Installation See JES2
preferences Initialization and
Tuning Manual.
Following is an example of the JES2 Initialization Dataset
required commands:
Table E-2.JES2 Initialization Dataset commands example
PROC=FSSPROC1,HASPFSSM=HASPFSSM,AUTOSTOP=YES
CLASS=E,FSS=FSS1,MODE=FSS,PRESELCT=YES,
START-NO,TRKCELL=YES,WS=(Q)
Follow these steps to configure the PSF printer in JES3:
1. Locate the JES3 initialization dataset (commonly known as
Initialization Deck) in the JES3 catalogued JCL Procedure.
(This is normally kept in SYS1.PROCLIB, although your system
may use a different library.)
The JES3 PROC has a JES3IN DD statement, which points to
the initialization dataset. The default initialization deck is in
SYS1.SAMPLIB (member JES3IN00); however, you should
verify your location by looking at the JES3 procedure.
2. Enter the following required commands in the JES3 initialization
deck to define the PSF functional subsystem (FSS):
•
•
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
YES specifies for IPS that
there is either offsetting or
stitching of jobs, subject to
value of COPYMARK
parameter and setting on
IPS.
MODE=FSS should be
specified.
Specifies whether output
datasets are preselected
for this FSA.
If WS if F, only output with
these destinations is
selected for this printer.
START=NO should be
specified so TCP/IP can be
started before the FSS.
IBM recommends YES.
Consider CL, R, and F.
(See JES2 Initialization
and Tuning Manual.)
One FSSDEF statement for each PSF functional
subsystem
One DEVICE statement for each functional subsystem
application (FSA) under control of the FSS.
Your value