Xerox DocuPrint 180 IPS Installation Planning Manual page 56

CONTROLLER SPECIFICATIONS AND REQUIREMENTS
HCU placement (channel-attached systems only)
5-8
The following shows the recommended HCU hardware placement,
for channel-attached systems.
Figure 5-6. HCU hardware (for channel-attached systems)
1 HCU
2 Table
Do not:
•
Do not place the controller monitor on top of the processor.
•
Do not allow any piece of equipment to blow warm air into the
air intake vents of the processor.
•
Do not place the processor on its side, or in any other position
but the upright, vertical position shown in the previous figure.
•
Do not place the processor or monitor on top of the printer.
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE