Sun Ultra 60 Workstation - Xerox DocuPrint 180 IPS Installation Planning Manual

CONTROLLER COMPONENTS AND OPTIONS

Sun Ultra 60 workstation

2-4
Keyboard The keyboard consists of alphanumeric keys similar to a typewriter,
symbols and special character keys, an extended character set, and
function keys. The keyboard is one of your main methods of
communicating with the printer. You can use the keyboard to make
selections, and to enter commands that control functions such as
requesting sample prints, obtaining billing meter totals, shutting down
the system, and so forth.
Mouse The mouse is another main method of communicating with the
printer. The mouse has three buttons. The left and right buttons are
used to select IPS functions. The center button provides additional
functions that you will not be required to use. If your workstation has
an optical mouse, it must remain on its designated metallic pad to be
active. If the mouse has a roller ball instead of an optical sensor
underneath, it requires a non-metallic pad.
Note: Printer controller hardware configurations are subject to
upgrade.
The Sun Ultra 60 workstation provides a user interface to the print
engine. It has a high performance RISC processor chipset, based on
the industry standard Scalable Processor Architecture (SPARC). It is
used to operate the software that controls the printer. The
workstation contains the following hardware components:
•
Sun Ultra 60 workstation processor (system unit)
•
Display monitor
•
Keyboard and mouse
•
Diskette, CD-ROM, and cartridge tape drives
•
Connectivity board for Ethernet and, optionally, Token Ring
•
A Data Control Interface Module (PDCIMu) card installed in the
processor to interface with the print engine.
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE