Xerox DocuPrint 180 IPS Installation Planning Manual page 165

ping
Verifying connection to host system LOOPBACK at address 9.9.999.999.
Connection verification 1 took .000 seconds.
verifications.
Connection verification 2 took .000 seconds.
verifications.
Connection verification 3 took .001 seconds.
verifications.
Connection verification 4 took .000 seconds.
verifications.
Connection verification 5 took .000 seconds.
verifications.
Round-trip (in milliseconds) min/avg/max = 0/0/1
Connection verification statistics:
ping
Verifying connection to host system TEST at address 9.9.999.999.
No response from host within 10 seconds for connection verification 1.
No response from host within 10 seconds for connection verification 2.
No response from host within 10 seconds for connection verification 3
No response from host within 10 seconds for connection verification 4.
No response from host within 10 seconds for connection verification 5.
Connection verification statistics:
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
If the ping is successful:
Table E-18.Example of a successful ping – AS/400
9.9.999.999
Note: A successful ping usually indicates that the AS/400 system
can communicate with the IPS. However, you could receive a
successful ping even if the IP address of the TCP/IP-attached printer
is a duplicate of another IP address.
If PSF output for this printer prints elsewhere, follow these steps
to determine whether the IP address of the printer is unique:
1. Power off the printer.
2. Wait at least five minutes for TCP/IP to clear the Address
3. Enter the ping command again at the AS/400 system.
4. If you receive a successful response to the ping command this
If the ping is unsuccessful:
Table E-19.Example of an unsuccessful ping – AS/400
9.9.999.999
If your ping is not successful, verify the following:
•
•
•
•
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
5 of 5 successful (100 %).
Resolution Protocol (ARP) tables.
time, there is a duplicate IP address. Consult your network
administrator.
0 of 5 successful (0 %).
The printer is powered on.
TCP/IP has been started on the AS/400 (command: STRTCP).
The cables are properly connected between the printer and the
LAN.
The Network Interface Card (NIC) in the printer is functioning
properly. (Consult your Xerox service representative.)
1 successful connection
2 successful connection
3 successful connection
4 successful connection
5 successful connection
E-23