Xerox DocuPrint 180 IPS Installation Planning Manual page 83

Turning radius
Using the turning radius tables
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
You must also consider the width of the passageway when the
equipment must negotiate a corner, whether into a room, an elevator,
or another passageway.
There are L-shaped turns and T-shaped turns. The diagrams and the
tables that follow show the minimum space required to maneuver
through the turns.
Figure 6-17. T-shaped turn
1 Passage A
2 Passage B
Figure 6-18. L-shaped turn
1 Passage A
2 Passage B
To use the tables:
1. Measure the minimum width of the passage or doorway you
need to use. This is Passage A.
2. Find that number (or the next higher number) in the turning
radius table and read across to the corresponding minimum
value for Passage B, depending on the type of turn the
equipment must negotiate.
PRINTER SPECIFICATIONS AND REQUIREMENTS
6-25