Checking Printing; Checking Printed Paper; Checking At The Printing Check Position - Xerox 495 Operator's Manual

CHECKING PRINTING

Checking printing

Checking printed paper

Checking at the printing check position

Fuser Exit Guide
Back side printing check mirror
Page 5-14
The printer is capable of checking both the front-side and back-side print
quality and position (see "Front and back marking units" on page 2-2).
These can be monitored by:
• Checking the printed paper
• Checking at the printing check position
• Using the printing position check function
1. Stop printing after several pages and press the Eject button on the
touch screen to eject the prints in the stacker.
2. Take the prints out of the stacker table and check the print quality
and position.
Check the printing status at the printing check position in the printer.
1. Print several pages and open the fuser left door (see "Components
inside the Fuser Door" on page 2-6).
2. Open the fuser exit guide and check the front-side printing status
(see "Front and back marking units" on page 2-2).
3. Check the back-side print quality and position using the back-side
printing check mirror.
4. Close the doors and restart printing.
Note: If printing is started immediately after autoloading, several
sheets should be printed until the first sheet is in position. The
number of sheets depends on the print page length.
Xerox 495 Continuous Feed Duplex Printer Operator Guide
PAPER PATH