Table of Contents
Advertisement
Electrical supply
Operator accessible areas
Maintenance
Cleaning your product
Page A-2
This product should be operated from the type of electrical supply
indicted on the data plate label located on the rear cover of the power
supply/transformer provided with the equipment. If you are not sure that
your electrical supply meets the requirements, please consult your local
power company for advice. The transformer provides 200V ac, 50 Hz, 3
phase as specified on the data plate of your Xerox 495 equipment.
WARNING: This product must be connected to a protective earth
circuit.
This equipment has been designed to provide operator access to safe
areas only. Operator access to hazardous areas is restricted using
covers or guards, which require a tool to enable removal. Never remove
these covers or guards. Please observe all warnings provided in access
areas.
Any operator maintenance procedures will be described in the customer
documentation supplied with the product. Do not to carry out any
maintenance on this product, which is not described in the customer
documentation.
Before cleaning, please switch off the equipment and turn off the breaker
on the distribution panel. Always use materials specifically designated for
this product, the use of other materials may result in poor performance
and may create a hazardous situation. Do not use aerosol cleaners, they
may be explosive and flammable under certain circumstances.
Xerox 495 Continuous Feed Duplex Printer Operator Guide
Advertisement
Table of Contents
