Xerox 495 Operator's Manual page 186

ERROR CODES
Code Display Message
0A-01 Cleaner blade A missing
0A-02 Cleaner blade B missing
0A-03 Kit A[R3a] end of life
0A-04 Kit B[R3b] end of life
0B-01 Smoke filter end of life
0D-02 Splice guide pins held up
0D-03 Splice guide pins held up (during
printing or emergency stop)
0D-04 Paper not loaded
0D-06 Fold-out/-in check
0D-07 Paper already loaded
Page 9-22
1. Cleaner blade A has not been installed (see "Replacing the
cleaner brush and blade" on page 8-18).
2. Press RESET on the touch screen.
1. Cleaner blade B has not been installed (see "Replacing the
cleaner brush and blade" on page 8-18).
2. Press RESET on the touch screen.
If you would like to change this consumable now then go to the
Consumables view and press the Change button to replace kit
A[R3a].
If you would like to change this consumable now then go to the
Consumables view and press the Change button to replace kit
B[R3b].
If you would like to change this consumable now then go to the
Consumables view and press the Change button to replace the
smoke filter.
The splice guide pins need to be lowered.
1. Lower the splice guide lever.
2. Press RESET on the touch screen and then set the printer to
ready.
The splice guide pins need to be lowered and the paper realigned.
1. Lower the splice guide lever.
2. Press RESET on the touch screen.
3. Press FOLD-OUT/-IN on the autoload panel to select the
correct paper fold.
4. Press RESET on the touch screen and then set the printer to
ready.
1. Open the right stacker door.
2. Empty the stacker table.
3. Press AUTO on the stacker panel to raise the stacker table to
the printing position.
4. Close the right stacker door.
5. Press RESET on the touch screen.
6. Load the paper automatically (see "Paper autoloading" on page
5-4).
7. Press RESET on the touch screen and set the printer to ready.
The paper perforation needs to be realigned (see "Setting the perfo-
ration position" on page 5-9).
There was already paper in the printer when the LOAD switch was
pressed.
1. Remove the paper from the printer (see "Removing Paper" on
page 5-12).
2. Reload the paper (see "Paper Loading" on page 5-3) or press
FORWARD/REVERSE on the autoload panel, to correct the
paper alignment.
3. Press FOLD-OUT/-IN on the autoload panel to select the
correct paper fold.
4. Press RESET on the touch screen and then set the printer to
ready.
Xerox 495 Continuous Feed Duplex Printer Operator Guide
Procedure
PROBLEM SOLVING