Removing Non-Fused Paper - Xerox 495 Operator's Manual

CLEARING PAPER JAMS

Removing non-fused paper

Page 9-6
14. Hold the fuser exit guide lever and open the guide completely.
After checking for jammed paper, carefully close the guide.
15. Close the Fuser Left door and open the Right Stacker door.
16. While holding the pinch roller unit lever, pull the lock bracket to open
the unit completely.
After checking for jammed paper, close the unit carefully until it is
locked.
17. Close the right stacker door.
1. Open the right stacker door and press the stacker table DOWN
switch. After the stacker has moved down about 10 cm, press the
STOP switch.
2. Cut the top perforation of the paper.
3. Release the paper tension selector lever.
4. If the paper is not badly torn and can be transported by the tractors,
remove the paper as shown in this step. If the paper is badly torn
then go to step 5.
• Press the RESET button on the stacker panel.
Fuser Exit Guide
Lever
Pinch Roller Unit
Lever
Xerox 495 Continuous Feed Duplex Printer Operator Guide
PROBLEM SOLVING