Calibrating The Scanner At The Document Glass - Xerox Phaser 8510 User Manual

Calibrating the Scanner at the Document Glass

To calibrate the scanner at the document glass:
1.
Place the Scanner Calibration page on the document glass, with the top edge of the page
toward the left.
Note:
Make sure the calibration page is aligned correctly. If the page is misaligned, the
calibration procedure will fail.
2. Close the document feeder.
3. On the control panel, select
the calibration page.
4. Wait for the scan to be completed, and then select one of the following options:
If the control panel indicates
■
■ If the control panel indicates
5.
Remove the Scanner Calibration page from the document glass.
■ If you have a document feeder, continue with the steps in the
section.
■ If you have a document glass cover, you have completed scanner calibration.
Phaser® 8560MFP/8860MFP Multifunction Printer
, and then press the OK button to scan
Document Glass Step
, press the OK button, and then go to Step 5.
Success
, press the OK button, and then repeat Steps 1–4.
Failure
5-32
Calibrating the Scanner
Document Feeder