Smudges Or Smears - Xerox Phaser 8510 User Manual

Smudges or Smears

Problem
Smudges or smears appear on the page.
Solution
To prevent smudges or smears from appearing on the page:
1. Verify that the paper you are using is the correct type for the system and is properly loaded
in the tray. For information on support paper types and weights, print the Paper Tips page.
a. On the control panel, press the System button.
b. Select
Information
c.
Select
Information Pages
d. Select
Paper Tips Page
2. If the problem continues, run cleaning pages through the system:
a. On the control panel, press the System button.
b. Select
Troubleshooting
c.
Select
Print Quality Problems
d.
Select Remove Print Smears
ink from the rollers by running several sheets of paper through the system. Repeat
Step 2 up to three times if the smears continue to appear.
3. If the problem continues:
a. Open the door on the side of the system and remove the maintenance kit.
b. Wipe the plastic wiper blade with a lint-free cloth.
c. Replace the maintenance kit and close the door.
Note:
Smudges or smears may appear if you print on side two of pre-printed paper, but do not
select 2nds Side as the paper type. Select the
printer driver.
See also:
Manual 2-Sided Printing
Cleaning the Maintenance Kit Wiper Blade
Phaser® 8560MFP/8860MFP Multifunction Printer
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button. The system cleans the
2nd Side
on page 3-28
on page 8-15
7-7
Solving Print-Quality Problems
option on the control panel and in the