Xerox Phaser 8510 User Manual page 92

4. Insert the tray into the tray slot, and then push it completely into the system.
Note: Do not load glossy paper above the transparency fill line inside the tray.
Overloading the tray may cause jams.
5. On the control panel, press the System button.
a. Select
Paper Tray Setup
b.
Select
Tray 2 Paper
c. Select
Use current setup
if the appropriate paper type is not displayed. Select the appropriate paper type,
setup
and then press the OK button:
■
Card Stock
■ Glossy Paper
6.
In the printer driver, select the appropriate paper type or the appropriate tray as the paper
source.
Phaser® 8560MFP/8860MFP Multifunction Printer
, and then press the OK button.
, , or
Tray 3 Paper Tray 4 Paper
if the appropriate paper type is displayed, or select
(Phaser 8560MFP printer)
(Phaser 8860MFP printer)
3-54
8860mfp-098
, and then press the OK button.
Change