Overview Of Network Setup And Configuration - Xerox Phaser 8510 User Manual

Overview of Network Setup and Configuration

To set up and configure the network:
1. Turn on the product and the computer.
2. Connect the product to the network using the recommended hardware and cables.
3. Configure the product's network address, which is required to identify the product on the
network.
■ Windows operating products: Run the Installer on the Software and Documentation
CD-ROM to automatically set the product's IP address if the product is connected to
an established TCP/IP network. You can also manually set the printer's IP address on
the control panel. Once the IP address is set, continue the installation procedure to
install the driver software.
■ Macintosh products: Manually set the product's network address (for TCP/IP) on the
control panel. Install the driver software on the computer from the Software and
Documentation CD-ROM.
Note: For information on driver installation, see the section in this chapter for the specific
operating product you are using.
If the Software and Documentation CD-ROM is not available, you can download the latest
driver from the Xerox Drivers and Downloads website:
■ www.xerox.com/office/8560MFPdrivers
■ www.xerox.com/office/8860MFPdrivers
See also:
Advanced Features Guide at
www.xerox.com/office/8860MFPsupport
Phaser® 8560MFP/8860MFP Multifunction Printer
Overview of Network Setup and Configuration
(Phaser 8560MFP printer)
(Phaser 8860MFP printer)
www.xerox.com/office/8560MFPsupport
2-2
or