Xerox Phaser 8510 User Manual page 195

2. Pull the waste tray (labeled B) completely out of the system.
Warning: The waste tray may be hot; handle it carefully.
Note: The waste tray may be locked if the system is in a warm-up cycle or if the ink is
cooling following the
locked, close the door and wait 15 minutes before repeating Steps 1 and 2.
3.
Empty the waste tray in a waste container. The ink is non-toxic and can be discarded as
normal office waste.
Note:
The waste tray must be out of the system for more than five seconds or you will
continue to receive a
Phaser® 8560MFP/8860MFP Multifunction Printer
Eliminate Light Stripes
message on the control panel.
Waste Tray Full
8-6
Maintenance and Cleaning
8860mfp-056
troubleshooting routine. If the tray is
8860mfp-057