Calibrating The Scanner; Starting The Calibration Procedure - Xerox Phaser 8510 User Manual

Calibrating the Scanner

This section includes:
■

Starting the Calibration Procedure

■ Calibrating the Scanner at the Document Glass
Calibrating the Scanner at the Document Feeder
■
Perform the scanner calibration procedure if your scanner, document feeder, or document
cover is replaced. Scanner calibration adjusts the output quality of the front and back pages of
2-sided originals in relation to each other. This procedure should not be performed as part
of normal system operation.
Calibrate the scanner using the Scanner Calibration page
that came with your replacement scanner, document feeder,
or document cover. After you begin the calibration
procedure at the control panel, calibrate the scanner using a
two-step process:
The first step scans the calibration page from the
■
document glass. Follow the steps in the Document
Glass section. (For systems without a document feeder,
only use the steps in this section to calibrate the
scanner.)
The second step scans the calibration page through the
■
document feeder. Follow the steps in the Document
Feeder section.
Starting the Calibration Procedure
1. On the control panel, press the System button.
2. Select , and then press the OK button.
Information
3. Select
Troubleshooting
4. Select
Service Tools
5. Select
Calibrate Scanner
Glass steps.
Phaser® 8560MFP/8860MFP Multifunction Printer
on page 5-31
, and then press the OK button.
, and then press the OK button.
, and then press the OK button. Continue with the Document
5-31
Calibrating the Scanner
on page 5-32
on page 5-33