Table of Contents
Advertisement
C
3
HAPTER
FIGURE 41. Two Tank with Two Pump Installation Example
To Recirculation
on Tank
CONNECT TANK TO FILL STATION
1. Connect tank one to fill side one of the fill station with 1" hose. Secure with the supplied hose clamps.
2. Connect tank two to fill side two of the fill station with 1" hose. Secure with the supplied hose clamps.
CONNECT FILL STATION TO PUMP
1. Connect the fill station for pump one to pump one plumbing with 1" hose. Secure with the supplied hose
clamps.
2. Connect the fill station for pump two to pump two plumbing with 1" hose. Secure with the supplied hose
clamps.
CONNECT RINSE
1. Connect the 3/4" hose to the rinse port of the rinse 3-way valve located under the tank. Secure with the
supplied hose clamps.
2. Route the hose to the rear of the machine.
3. Determine an appropriate location in front of the skid lower cross tube to install the rinse tee.
4. Cut the hose and install the rinse tee. Secure with the supplied hose clamps.
5. Connect the rinse tee to pumps one and two. Secure with the supplied hose clamps.
CONNECT PUMP RECIRCULATION OUTLET TO TANK
1. Connect the pump one recirculation output to tank one port with 1/2" hose. Secure with the supplied hose
clamps.
2. Connect the pump two recirculation output to the tank two port with 1/2" hose. Secure with the supplied hose
clamps.
CONNECT PUMP TO INJECTION POINT
1. Connect the pump one output to the injection point on the mixer with 1/2" hose. Secure with the supplied hose
clamps.
30
To Bottom of
Tank 1
To Bottom of
To Injection
Tank 2
Point
Fill 1
Fill 2
ICD Sidekick Pro Injection for Case Trident Installation Manual
To Recirculation
on Tank
To Injection
Point
To Rinse Tee
Advertisement
Table of Contents
