Support Tube Installation - Raven ICD Sidekick Pro Installation Manual

FIGURE 3. Bases on Lower Cross Tube
Lower
Cross
Tube
2. Slide U-bolts (P/N 107-0171-607) under the cross tube and up through the bases.
3. Install the U-bolts using the provided 3/8" washers and lock nuts. Do not tighten until the end.

SUPPORT TUBE INSTALLATION

1. Mount the support tubes (P/N 116-0159-823) to the installed mounting bases.
FIGURE 4. Support Tubes
Hardware
Locations
2. Secure with a 1/2" bolt, two washers, and a lock nut. Do not tighten at this time.
NOTE: All bolt assemblies used for this installation that are not U-bolts will be installed using a bolt, two
washers, and a lock nut as shown below.
P/N 016-0171-675 Rev. A
Bases
U-Bolt (x4)
Bases
INSTALLATION
Support
Tube
9